I have a Kuka mastering cable 00-181-058 that has the wires pulled from the connector. Would anyone happen to have the pinout for the small end that plugs into the mastering tool?
Mastering Cable Pinout
-
Mike70 -
September 6, 2023 at 7:54 PM -
Thread is Unresolved
-
- Go to Best Answer
-
MOM
September 6, 2023 at 8:43 PM Approved the thread. -
The SafeOp PDF should be on your robot, under D:\KUKA_OPT\SAFEOPERATION\. The information is in there. It should look a lot like this:
-
- Best Answer
he seem to be asking about mastering tool cable, not mastering reference check switch.
the part number does not tell me much, not sure if this is the SEMD or MEMD and which of the cables. it would be good to post picture of the damaged connector. by small end, i am guessing the pico (M8) connector that plugs into EMD.