Hello Everyone,
Was hoping to get some guidance or at the very least a point in the right direction for configuring arctech. I'm using a KR 2 R2700 with a Lincoln Powerwave R450 and have the general settings setup; Arctech on the robot and Lincoln Job mode added to the project from workvisual. The problem I'm really struggling with is how to fully configure all of the Input and Outputs alongside the Weldmodes in workvisual and what port should be used to connect the power source to the robot. I've looked through the Lincoln manual as well Kuka's Arctech manual, but there isn't anything truly specific. Any help at all would be very much appreciated!