Hello
In a new setup I would like the 7.th axis motor to follow the orentation of the TCP point.
Is that posseble?
And how?
I have looked om follower axis in manual but can not figure out how to set it up. or where to look.
Best regards
Hello
In a new setup I would like the 7.th axis motor to follow the orentation of the TCP point.
Is that posseble?
And how?
I have looked om follower axis in manual but can not figure out how to set it up. or where to look.
Best regards
Where is this 7th axis? On the flange of axis 6? External to the robot, like a turntable or tilting axis?