Hi there,
When re-mastering today with a dial indicator we noticed that a few of the axis have indistinct feedback as to the exact notch centres. We know this because two of the axis are much more positive in their reading so we feel these are correct. Either our dial indicator is not penetrating deep enough to give us a correct reading or I think the notch or pins on individual axis are out of alignment, worn or anything in between. Unfotunately borrowing, renting or buying an EMT has proved fruitless so we need to carry on with the dial and pen tip route. As far as we can tell the dial indicator itself is working fine.
My question is how can we check the pins and notches on the robot axis. Is it ok to extract the pins and inspect the notches?
Many thanks
KR125, KCR2EDO5, KSS5.5