Good morning,
I recently purchased a robot system with a YRC controller an miller auto continuim power source. I do all of my welding with the Accu-Pulse process. My older system is a NX100 with a auto axcess power supply. The weld conditions are not transferrable from one system to the other. the old sysyem would run 25 volts and 250 amps to acheive the desired weld.The new system requires 50 volts and 250 amps to do the same. Is there a way to change the scalaling so I can use my original weld settings? Also Can I only Parrallel shift using line numbers and not step numbers on the YRC?
Thanks,
Mike