Hi! All
I am trying to integrate the Fanuc ArcMate 100iB + R-J3iB controller with Fronius CMT.
Previously, Lincoln PowerWave F355i was attached to the R-J3iB controller, but it was detached, since we donot use the Lincoln power source. In stead, we are using Fronius CMT.
If we see the figure, the wire A and B are the connected wires to the previous Lincoln powerWave. And to turn on/off the CMT, we manually trigger it using pin C and D.
In this situation, I think if we simply plug the two wires into relay and relay to Pin C and D, the welding start and end can be automatically control on the teach pendant.
But, I do not know what to start at this moment.
If you have any experience or give me any comments on this, I will really appreciate it.
Thank you.