Hi All,
KRC4
KSS 8.5.7
I am wondering if anyone has used a Beckhoff EK1122_0000 rev 0.18 with a KRC for branching an ethercat network, I'm looking to do it to just ease some wiring on a machine.
I have it setup in the hardware config and have the topology setup as it is connected (see attached) but cannot seem to get the IO working and reset for some reason.
Cables are all good, headers are all good, its seems through the diagnostic monitor that it can't see the headers off the main bus.
Anyone set up something similar, I'm probably missing something stupid.