Hi everyone.
Im still rather new to the programming world so bare with me.
We have an r30ib which has an external hmi screen. My predecessor setup all di and uop stuff before he left.
I have the programs all set. All safety is correct. And it runs fine in local mode.
However when i switch to remote mode. And i press start to cycle, it wont go and the memo 73 message comes up. Program does not exist. How can it not exist if it runs locally?
I have checked all the config stuff such as ui signals etc and all is true.
It is an rsr0001 master program we run and then a register to select sub programs.
If r10[job selected]=1
Call full cycle
Im scratching my head as to why it wont run. Ethernet ip is alrwady set up and all other signals are working fine. So why wont it run?
Is there something in the variables it could be?
As i said. I only recently completed my tea h pendant training so am still a novice.
Any advice or tips greatly appreciated.