We have ordered a Fanuc setup and spec'd the 2d vision system. I was wondering If we wanted to try the 3DL package, is the controller software the same or do we need to change that also. Was hoping to be able to try both setups before deciding which to go with. Thanks
2d Irvision & 3DL Laser on the same M20 robot controller
-
kevinh1234 -
July 28, 2018 at 7:38 PM -
Thread is marked as Resolved.
-
-
The controller software is the same. The 3DL uses IRVision. I think the only difference is the hardware.
-
3DL requires additional software installed in the controller. If you were running both cameras, you would likely need a camera multiplexor board as well, although I am not sure about that on the new R30iB+ controller.