After Power Recycle ...My KRC2 2005 edition stop showing External axis option to jog Servogun. Plz help.
Servo Gun Option not visible
-
Nihar319 -
March 8, 2018 at 1:26 PM -
Thread is marked as Resolved.
-
-
You have not provided any DETAILS.
Did the robot reboot properly otherwise?
Are there error messages?
Has this problem occurred before when the robot has been rebooted?
What jog mode are you in?
What user group are you logged in under?
If you run a program that uses the servo gun, does the gun still actuate properly?
If you attempt to teach a Weld point, does the SeroGun inline form still operate correctly?