Hi All,
I have a Kawasaki UX150 (S/N 1068R0535) with a C42F-A001 controller. I am getting a robot-servo mismatch error. I have researched the forum and see that a few others have encountered this problem but I still have no idea where to start.
The robot has been out of production for a few years i'm guessing and the RAM batteries most-likely died. I have replaced those now.
The robot would not boot for me so I did a 'dip switch 8 initialisation' as per my reading of this forum. This allowed the robot to boot up but I now have a robot-servo mismatch error among some others.
I am entirely new to Kawasaki robots and so have no idea where to start. I don't have any backups (Unless they're stored somewhere in the robot that I dont know about) nor do I have any idea how to connect to the controller with my PC or even what software I would need.
Attached is an image of my 'AUX90' screen. As you can see, there is some info here and I am of the understanding that this should be blank after 'dip switch 8 initialisation'. Is this a good sign?
The robot came out of a Land/Range rover factory somewhere in the UK if that info is of any benefit.
Any help would be appreciated as I am lost!
Many thanks in advance.