Status button on the pendant (at the bottom), Then hit F1 for TYPE -> VERSION ID then hit F3 for config. In there lists everything installed on the robot. If Karel is in there you will see it.
Essentially you write karel in any text editor. I would recommend notepad++. You also need a compiler to convert into .pc files that the controller can use. Roboguide, a fanuc owned software is used to write offline programming and can help you write and implement karel code most directly. you can also do this with winolpc.
If you are new to writing in Karel, I strongly recommend going through a post by SirCumference by the title "How to write Karel Programs". rf103 gave some good notes
A good start would be this article http://www.onerobotics.com/posts/2013/int…el-programming/; I use Sublime3 as text editor for which I setup a comfortable environment with custom syntax highligthing and snippets; to build I use the ktrans command line which comes installed with ROBOGUIDE (you can install the trial version and the command will work even without a license)
Thanks.I see
KAREL Cmd. Language
KAREL Run-Time EnvI am assuming that indicates it is installed.
What do I need on my PC to write and compile KAREL compatible programs?
It looks like the actual Karel option is R632. It looks like the other two Karel options are for internal Karel programs.
It looks like the actual Karel option is R632. It looks like the other two Karel options are for internal Karel programs.
I'm not sure 632 is actually needed. I've been able to run Karel programs on controllers without it, as long as some of the others were present.
Those controllers did sometimes need the $KAREL_ENB variable to be updated (set to 1).
Hello, and how can install the Karel Option, some one can help me?
KAREL is a paid option (R632). First step would be to contact your local FANUC rep and buy the option. Installation procedure could slightly differ, depending on where you are from.
thanks
