Anyone have any experience using Fastart? Does this cause burnback issues? Arc start fails etc? and is this a feature once enabled in S.V. become an option in Weld Procedure for adjusting?
"FAStart"???
-
RoboGuy -
October 10, 2017 at 2:50 PM -
Thread is marked as Resolved.
-
-
I have used it with decent success. Knocked .3 sec off each start. Just need to check weld lengths and overlap. I used production stat variables to collect data before enabling and after. No effect on arcstart failures, BB, or WS.
-
THANKS!
-
further to that you can set arc end time to 300 also and set arc detect time, pre-flow and post-flow all to 0.0. These are global settings, but knock off significant time.
-
just adjust a delay in weld schedule parameter delay= .2 sec or .5 sec
to avoid burn back, check gnd, verify that your reamer or service station is working