Hi all,
Like many others, I've purchased an EK1100, 1809 and 2809 to run some digital I/O. I've scoured the history of the forum and have tried each solution. When I use the data files from Beckhoff website I get errors "Error on reading/writing: SYS-X44" and "<SYS-X44> Error during ECat stack initialization [Network response () no network response]" . When I attempt to use the DTM files that Panic Mode put up from 2015 the 2809 provides no channels to map the outputs to (image attached), so I tried only leaving the 1809 on the stack and removing the 2809 from WoV and now I only get the "<SYS-X44> Error during ECat stack initialization [Network response () no network response]" error. I'm using WoV 4.0.14_Build0060 - might that be the problem? V8.3.20 on the controller, and I've followed each historical post from this forum that I could find step by step with no luck. Any help is greatly appreciated.