I've been working with NX100 robotic welders for about 4 months now. The most I've really gone in depth with is editing points in jobs and repairing fixture and robot errors. I'd like more insight into writing a job from scratch, how to call outputs, how to insert a weld program from our SKS interface, how many comment to appropriately give that job without gaining too much cycle time, and how to call that job through a master job. Any tips?
New to programming robots. Looking for more info than the basic NX100 manual.
-
CollisionDetect -
February 27, 2017 at 6:40 AM -
Thread is marked as Resolved.
-
-
Hi , send me a PM with your email address and I'll Fwd the NX100 operator Manual.( for Arc Welding) .
Although the Motoman.com Webb site , has large range of manuals, it's a bit differcult to single it out.
Earlier models had a basic operators manual available however I'm not aware of NX100 having this. -
hope you got this resolved, but if not send me an email to eliseo896@gmail.com I downloaded the manual from motorman long time ago and still have it that if you cant find it in the motoman support documents