Battery Alarm

Alexandru · January 9, 2017 at 12:49 PM

Hello,

On Dedicated Output Signals there is an option "Battery Alarm". This option will alarm you when the battery need to be changed?

For example Dedicated Signal 2500 and into a background program will have something like:

IF SIG(2500) THEN
$message1 = "Please change the battery."
IFPWPRINT 1,1,1,2,7 = $message1
END

**kwakisaki** · January 15, 2017 at 8:11 PM

I've never used it......but there are only 2 batteries in an E Controller, so it must be tied to one or both of them...........

If your feeling brave...........I accept no liability..............
- Disconnect the encoder battery and see if it triggers your command (encoder battery usually has a dedicated warning error -W)
- Remove the Coin Cell battery from the 1TA/1VA Board and see if it triggers your command.

Battery Alarm

Advertising from our partners

Anyware Robotics is hiring!

How to see your Job Posting (search or recruit) here in Robot-Forum.com