Hi
I have a paint robot which i powered up yesterday without any issue, this morning when i turned it on, i got the error SRVO-68 DTERR
I checked all the connections, made sure the ground is properly connected, when i switch the controller with similar robot controller, the arm
working fine without issue, attached are the pictures of Teach pendant.
Please
Paint robot R30-iA error SRVO-68 DTERR
-
robotatwork -
November 3, 2016 at 4:12 AM -
Thread is marked as Resolved.
-
-
Just attached the picture.
-
Hi Chris
I tried most of the solutions, since the arm is working fine with other controller, do i still need to replace pulse coder? i will try to switch amplifier tomorrow,
i am thinking this probably something minor as i was working on the unit last night fine. -
Check the screw clamps that press down on the cable shields where they enter the cabinet. I had this same problem a while back and was recommended to check these. They were all loose and tightening them took care of the problem and it has not returned.