When opening the jaw inside the block is there a way to make it not open so hard and move the blocks. Also conveyer moves different distance every time so cant get the program right.
Fanuc lr mate 200 id 4s
-
17kuhlc -
November 1, 2016 at 2:48 PM -
Thread is marked as Resolved.
-
-
You need to give more information on the application you have and what you are actually needing help with. "opening hard" could mean high air pressure or lack of flow control on the gripper, etc. Need more info. The conveyor issue might have something to do with sensing a part that is in a different position each time. Is there a VFD on the conveyor, is it a DC drive? Is it a contactor that controls it? Being vague with the question will not get you good results with the replies.