Ok now the j1 j2 and j3 work fine but j4 j5 and j6 dont go right ways
Posts by 17kuhlc
-
-
Now im getting motn 063 position config change g:1
-
Im only seeing 1 witness mark
-
How did you get all that code into there or is that not what im supposed to do
-
Sorry new to this where do i go to create that and where are the witness marks
-
How do i create a zero program hard to get everything back to zero with axis all going wrong ways
-
Tried those steps and it still does not work correctly axis are not moving right.
-
Our fanuc here had a pulse issue after batteries were changed once we cleared that now our coordinates and the way the arm moves are all out of wack any ideas on a fix
-
When opening the jaw inside the block is there a way to make it not open so hard and move the blocks. Also conveyer moves different distance every time so cant get the program right.
-
How do i do that all im doing is trying to get the camera position for setup
-
Mine is at 250 and i turned the percentage to 5 percent and still got this error its motn 074 code
-
It does not let me set it to zero says out of range
-
where is $speedlim cant find it anywhere
-
Where is the override speed and when I look in variable speedlim is not in there
-
Our Fanuc here at school keeps giving me the error code MOTN-074. How is this fixed it is the LR Mate 200 ID I am trying to set the camera position. Thanks