Dear Experts!!
Hello!!!
I have one MS100/MH110-A00, DX200 Controllers.
I am communicating my robot with MITSUBSHI Q06UDV PLC over cc-link.
I have done cc-link setup of that robot in maintenance mode like : Station occupied : 4, Station no. 1, B.Rate : 2.5Mbps etc.
Now i doing diagnostic of cc-link in my PLC and its showing perfectly fine. IT IS NOT SHOWING ANY KIND OF ERROR.
When , I turn on my 1st bit of cc-link, #20070 gets ON. I turn on my 16th bit of cc-link, #20087 gets ON.
Now when i turn on my 17th bit #20090 does not get ON and so on, none of the bit gets on after 17th.
I faced this kind of problem very first time. What can be the problem.