Hi ALL,
I would like to check how to execute 2 job at a time from Master Job.
In the manual it state as follow and i don't quite understand how to do it.
“DIN LB000 IG#(1)” described in MASTER.JBI is the instruction to read
the signal input of the first user input group (8 inputs per group).
The first user input group consists of 8 inputs from #00010 to #00017, and
each user input represents the numerical value shown in Table 4-31 Input
Number and Assigned Numerical Values of First User Input Group.
#00016 represents “64”, and thus LB000 = 64 is set, and 64.JBI is
executed by JUMP LB000.
1) How do i set the Assigned Numerical Values to represent my JOB in the User Input?
2) If I name my JOB as "Standby.JBI" instead of 64.JBI how should i do it?
Appreciate if any expert could advise me
Regards