dear kwakisaki
I found something in as program
I have c70 controller that I can connect with KRterm to it.
In SYSDATA I have:
FDD_SPD_BAU 96 96
FDD_SPD_STOP 2 2
FDD_PORT 1
FDD_SWITCH -1
But in c40 controller that one I can not connected to it .
I have this:
FDD_SPD_BAU 384 384
FDD_SPD_STOP 2 2
FDD_PORT 2
FDD_SWITCH -1
There are two different port number.
What do you think about that?
In c70 port2 is free but in c40 port 2 is used.
I'm afraid to change it to 1
Cause I only can connect with this controller with flappy drive
And if I change port to 1 and after that I can not to connet FDD drive
to it......
I don't have anyway to connect to it.