Hi peeps,
I ran the load identify program for a tool we mounted on a 6400 2.8/200. I want to take the same tool and mount it on a 6400 2.5/200. Would the center of gravity data values change a whole lot due to the longer/shorter arm reaches? I'm thinking it would be ok copying those in to the 2.5? Thanks for any input given!
Center of gravity
-
kickdrumcurtis -
November 12, 2015 at 12:36 AM -
Thread is marked as Resolved.
-
-
Interesting question. Part of me thinks the CG is with respect to faceplate center, another part thinks the torque moment would be different with different arm lengths.
-
Thanks Iowan,
I am just going to run the test on the 2.5 and see the differences so I know for sure. Appreciate your time. -
Post the results - my curiosity is piqued.
-
There will be a little influence but that is ok from my experience.