Would someone know how to use inline form in the WorkVisual ?
check the picture, how did it ?
inline form in WorkVisual?
-
irobot -
June 24, 2015 at 8:52 AM -
Thread is marked as Resolved.
-
-
Hi,
You can go in editor and then open the src file. Wherever you want to put the inline form, you can right click and select "Insert Snippet" and it will give you a list of Instructions, etc and you can select whichever you like to use.
Thanks
-
that doesnt work as it doesnt populate the dat file. use orange edit instead which does work.
-
Yes, I agree but sometimes the inline form generated in Orange Edit also gives compilation errors. So, I prefer to introduce motions directly from SmartPad which is always good.
-
Hi,You can go in editor and then open the src file. Wherever you want to put the inline form, you can right click and select "Insert Snippet" and it will give you a list of Instructions, etc and you can select whichever you like to use.
Thanks
But why there is nothing created in the data file?
If I insert an inline form in Orange Editor, there will be some data like XP1, FP1 and PPDAT1 created in the data file.
I think Workvisaul is not helpful for programming!
-
Hhhhhmmmm...
I agree with your point. It seems like KUKA gave more emphasis while developing Work Visual on networking and hardware configuration part. And there are many other differences between KSS and Work Visual. Work Visual is a tool to do offline programming of the robot which means you can develop conditional programs in it. But to write the motion instructions one need to be close to the robot or use Simulation software so there comes KSS in which one can write the motions and touch them up.
Thanks
-
Would someone know how to use inline form in the WorkVisual ?
check the picture, how did it ?
Wich version o WoV is this, irobot?I remember to see this ILF on older releases (2.1.x), but since 2.2, I think KUKA removed this and favored the snippets insertion.
-
the pic came from a vedio, I do not know the version
and thanks your information