Hello everybody,
I am new in the forum, new in the KUKA world as well. I recently acquired a KR210 2000 series. I use it for foam carving and light milling.
My controller is a 2004 (V)KRC2 with 434Mhz processor, runs on Windows XP SP1 with DSE card installed. KSS v.5.4.14.
Not very technically savvy, if I am omitting any important info that would help clarify the case please let me know.
I am trying to expand the existing RAM from 3x64MB to 3x256MB. KUKA USA sold me two cards that they had available last week for my controller(part number 39000082), I installed them in place of two of the 64MB ones and after booting with cold start I expected to see under Help/info a total of 576MB of RAM.
However, it appeared as if I only had 320MB RAM. I tried a number of different combinations to rule-out a damaged RAM, both installed separately with an additional 64MB card work fine. It almost looks like the system can only handle up to 320MB. Interestingly enough, any other attempted combination that would result to a total over 320MB drops the memory reading to 256MB or 320MB. For example, 2x256MB + 1x64MB shows as 320MB RAM and 2x256MB + 0x64MB shows as 256MB.
Not the end of the world of course if my upper bound is 320MB but if anybody here thinks that could share some knowledge, I would be greatly appreciative.
Thank you.