I wanna give a output to the plc during the motion but motion must not be disturbed. In this case which is better trigger path or sync out what is the difference between the two?
Eg
LIN f10_P230 CONT Vel=0.3 m/s cpdat856
wait sec 0
SYN OUT 49 '' State=TRUE at START Delay=1 ms
LIN f10_P240 CONT Vel=0.3 m/s cpdat857
which is better trigger or syn out?
-
knowledgesharing -
July 21, 2014 at 7:28 AM -
Thread is marked as Resolved.
-
-
A SYN_OUT is nothing more than a standard TRIGGER command, wrapped inside an "easy mode" Inline Form in the KUKA HMI. SYN_OUTs are easy to use, but writing your own TRIGGER commands is far more flexible.