We are having some issues with our CS8C controller, where the system is not booting up properly. When the power is switched on, the MCP is stuck at the Staubli logo page, and doesn't go into the menus after a minute or two. I've read in the SRS manual that there is a TCP remote maintenance tool, but there is no information on what software/configuration is required to access this, does someone have this information?
For those interested, these are the error indicators on the controller:
- RSI: the three LEDs for power status (D49, D50 and D52): D49 and D50 are on, D52 is off (5V from STARC board). We checked the power LEDs inside STARC (1.2V, 1.4V, 2.5V, 3.3V and 5V), all 5 LEDs are on, indicating that there is in fact 5V at the STARC board. 7-segment display has a flashing ‘E.’ (~1 second).
- STARC: the 5 LEDs (A-E): D and E are on (orange), A and B are flashing slowly (red), C is off.
Any suggestions/recommendations would be much appreciated.