Hi,
I'm a electrical engineer and I work on a artificial intelligent project for a automated silicone potting machine for electronic board . To validate my software, I use a old prehistoric MRC controller and a K3 arm. I programmed the software with Labview/vision. I did a communication layer with labview to command the robot arm. BUT, I'm stock with the configuration of the MRC parameters (RS). I can't find where they are. I have already set the Remote in the maintenance mode (7). I have selected "command" and disable I/O and PP. Now I can't enable the remote on the control box. What i'm doing wrong?
Regards,
Dave