Yes that is possible if i hold jt 4 disconnected.
Posts by W4e
-
-
Yes when i try to run it keeps running without error
-
Nothing at the moment. We want to make it pick and place. We had the first step with the welding. But now it breaked.
But when i unplug the motor only it give no errors.
-
Yes that one is broken. And cracked but it is motor 3
-
-
-
Those work all correct in teach mode.
-
-
-
Then i need to remove them of the robot. I inspect that p50b08100vcxs9 and saw that too on the jt 6 too 5 i cant see it.
So let me know what you want.
-
5 and 6 has the same.
-
You mean this? I had this of motor 4
-
Ok i tested. All has OL on the test.
-
Oh i thought you mean the test you Said above. With swapping jt4 and 5. Ah sorry again i Will test now
-
So i swapped all and jt4 still vibrating and give error on -1503 speed error jt 4
-
-
After enable power and try to move the motor i got this sound. The robot doesnt move but vibrate only. No error i got once the -1503 speed error jt 4
-
Sorry when i tried to remove servo board i found a losse connector. Now the problem that i found in the first place is compleet back.
-
-
Ok i place everything back. I got this error -1417 p-n of jt 4 overcurrent. I didnt do anything of your changes yet. Should i do it now?