I am looking for the part number for the joint 5 and 6 harness on a M16i GM robot. It has 4 white plastic connectors on the back end and 2 white connectors for JT6 and two black connectors for joint 5. Any help would be greatly appreciated. I do not have a parts manual for this robot.
Posts by ironcollarworker
-
-
Select is set to Other and UOP like the robot next to it which works fine on an older version of software.
-
Every time I put this to 1 it sends the unit back into remote. I check the config and it says Local. Entering a 1 puts it into remote. Still no luck cycle starting starting this one with SOP. Any other suggestions? This unit is running version 6.40 XA-X. It is the only one I cant get to work!
-
Thanks but I had already done that. I think it has something to do with $shell_cfg
. -
Does anyone know what system variables have to be changed in order to get a 2000iA with an RJ3iB GM controller to cycle start from the SOP?
Thanks
-
Does anyone know the part number for the battery packs in a Motoman UP6? I nned the numbers for the Manipulator. 3 pack and 2 pack Thanks
-
It worked Thanks!
-
Still no luck with this. ED
-
Thank you very much. It worked perfectly!
-
Does anyone have a step by step on resetting the controller after changing the batteries. This is a small training robot I am trying to get running for the school. Thanks!
-
Our XRC up6 was stored for too long. I need help getting the teach pendant back to English. Thanks in advance.
-
does a Fanuc servo torch have to be mastered?
-
Does anyone know the part number for the LCD screen of a 3HAC028357-001. I tried calling ABB but they seem more confused then usual.
-
This message is normal and comes from the teach pendant itself. Check your connections. It sounds like the software is not running. Check the status of the lights on the boards.
-
Does anyone know if ABB sells the touch screen part by itself and if so what is the part number. Thanks
-
Does anyone know the part number for a M20iA mechanical drawing set so I can buy one. Our maintenance man was supposed to take off the EOAT and instead unbolted the larger retaining ring. HELP
-
Does anyone have the pinout for a IRC5 120 series robot. The circuit diagram in the manual is a blank page.
Thanks!
-
We still have 6000 S3 programmers available depending on the application. We installed two 6000's for a customer in May that came from Germany. If I can be of help let me know.
IronCollarWorker. -
Does any one have electrical prints for an AW controller. I am trying to hook up my I/O signals,
Thanks,
-
Any chance I could get a copy too? edeaton07@gmail.com . It would be greatly appreciated.