Posts by Mehrdad_ala
-
-
I thought there was a command line to reset the program,can't you tell me what to do here,I know you are tired of my questions,please tell me step by step what to do
-
panic mode , my question is completely different , I mean when my program is executed and finished,is it possible to reset the program with plc and it comes back to the first one,according to the picture , R ,which has turned black ,turns yellow again,reset program can it be done with plc?in this fashion?I am asking thus,if possible ,how can I do it?
-
I read the documentation , but I can't find where I am wrong.
Please help me again
-
and you were right,I didn't paid attention , and I set pgno_fbit to 17 , and this time the error program 0 not available came, can you tell me why we have to run this program?what happens when it run this program? What happens when it runs correctly ? And what to do with the information I sent I will do it until the end , thank you dear panic mode
-
what I mean by program reset is the picture below,you can see that the program has been run once and finished , now I want to run this program again from the beginning without going to t1 mode,how can I do it ?
-
how can I fix this problem?what should I do?
And another question ,after the program is executed , how to reset the program with plc,is there an entry (input) to reset the program?
-
I set pgno_parity to zero and this time this alarm came, program 4 not available -
my external I/O
-
dear panic mode thanks for you're helps,it's fixed.i have a small problem ,please tell me so that I can finish my work.i did all the things in the forum posts to use ext mode but when I set PGNO_VALID=true to plc,I get alarm,it gives parity error in program=0robot-forum.com/attachment/35442/
-
To use X11 as safety interface, ProfiSafe need to be turned off, which is done with WorkVisual. This means installing and configuring WorkVisual, getting working project from robot, saving it as new file name, turning off ProfiSafe, deploying and activating modified project, activating new safety configuration. Then X11 will be active..................
-
where can I see post #52 my friend?
-
Sorry dear panic mode , how can I change from profisafe to x11?please tell me this
-
yes,you are right dear panic mode.thank you for all the warnings you gave.
The plc I use Siemens 1200 (214_1ag40_oxb0).
And it is a standard plc.
Now the question is , can't I work with a robot with this plc?it must be a safety plc?
According to the picture, I didn't use the safe input and output.because it gave an error (can only used with an f_cpu) when compiling.
How can I use this account now ?this plc is not safety use.please help me again
-
-
Code
I still couldn't do this one alarm after all these messages and research and reading the datasheet, I don't have any problem with the communication between my plc and my robot, I just don't know why this error should come. I did the x11 wiring and it didn't work, I opened the block and I don't know what to do anymore? I sent you any information you need. Can't you think of anything else? I even used the get and put commands in tiaportal, which didn't help, and I don't think a special block is needed to destroy this. error
-
-
my system detail
-
I used profinet
-
panic mode