Tengo un robot motoman MA1900 y controlador DX100, conectado a una soldadora ABICOR BINZEL,al querer ejecutar un programa de da ese error cual podria ser el problema?gracias
Error 9079 welder 1: robot comunicacion
-
Pablo2214 -
February 6, 2024 at 3:30 PM -
Thread is Unresolved
-
-
Is this a new welder installed? Did this happen out of the blue?
How are you communicating with the welder?
- Profibus
- Profinet
- DeviceNet
- EtherNet/IP
- Modbus-TCP
The robot controller and the welder aren’t talking to each other.
-
Se comunican mediante devicenet,se quemo la soldadora se reparo, se volvio a conectar y ya me tira error 9079
PAGede ser una falla de comunicacion de parte del robot tmb no?
-
The robot controller isn’t receiving the watchdog signal from the welder.
Something is lost in translation. Something broke and was repaired with a soldering iron.
-
Dale gracias por la info moderador te agradesco