HI.I need some help here. We have a Fanuc robot here and it gets hand broken error every time, when it is not in use for around 1 hour min. So we have that every morning and the only way to get rid of it ,is to run it in manual mode for 10-20 minutes and then that error disappears .Once it disappears ,it is running smoothly all day long without any issue until next day morning. Any idea how to resolve it please?
Fanuc robot. Hand broken only when robot is not in use.
-
Artrobotic -
November 29, 2023 at 5:32 PM -
Thread is Unresolved
-
-
HawkME
November 29, 2023 at 5:57 PM Moved the thread from forum General Discussion of Industrial Robots Only to forum Fanuc Robot Forum. -
HawkME
November 29, 2023 at 5:58 PM Approved the thread. -
Sounds like mechanical wear. When was the air clutch last serviced?
-
Never, but it`s a new robot installed 2 years ago
-
Do you have any additional information, like a model number?
-
Hi.So the robot is ARC mate 100iD8L and controller R-30iB Plus