HI,
Where can I find the list of errors I use?
I created an error 8000 using SETUALM, but is it possible to actually see what section it is in?
for example in SYSTEM INFO or IN/OUT..
an other question!
in the I/O ALARM (user) section i found "low air pressure" in section 9064!
how can i see where this error is located and change the range?
thank you very much in advance 
Where can I find the list of errors I use?
I created an error 8000 using SETUALM, but is it possible to actually see what section it is in?
NO section available. You are using an inform instruction inside a job to create it.
Also be careful don't use it for safety purpose, because if you manage to stop a robot using the SMODE yaskawa doesn't guarantee the stop of the job.
Quotein the I/O ALARM (user) section i found "low air pressure" in section 9064!
how can i see where this error is located and change the range?
Usually the "low air pressure" is allocated from the factory to be easily usable. Yaskawa will give you also a "physical" access to the signal in the I/O connector ( usually CN309-A2) and a logical input signal ( usually 2027). I'm not sure that you can change it using the LADDER, you could only ignore it using another low air pressure made by you.
You need to be a member in order to leave a comment
