Hi everyone.
I have a question about EE connector. our robot is 120ib/10l and controller is rj3ib.
we put air solenoid to EE connector in order to control wire brake.
picture 1 is working fine based on pin layout in manual. manual says pin1 goes to RO1 and pin5 goes to 24v
problem is that we did exactly same setting on another robot (same model, same controller), as soon as we powered it one, solenoid is actuated right away continuously.
never turned off. default is on which is not correct.(please see picture 2)
Picture 1 and picture 2 look different a. it is upside down. I don't know that is matter or not.
to summarize it,
picture 1 is working with pin1-do1, pin5-24v.
picture 2 is not working with same setting(I also tried many different combination as well). solenoid is activated by default and never turned off(I can't control)
Any advice would be appreciate.
Thank you