Hi ALL masters,
Good day to all.
Does everyone know about this error? What is the recommend recovery step?
Does everyone have the manual of Kawasaki NX520 robot?
Thanks and appreciate for the info and guidance given.
Hi ALL masters,
Good day to all.
Does everyone know about this error? What is the recommend recovery step?
Does everyone have the manual of Kawasaki NX520 robot?
Thanks and appreciate for the info and guidance given.
Welcome to the forum.........
Unfortunately Kawasaki retains information for wafer handling robots and restricts information.
You will need to contact your local Kawasaki distributor for further information unless a member can provide some assistance.
Kawasaki use arm id boards throughout their other series of robots, so maybe there is some logic troubleshooting based around D controllers as I suspect that series will be using D6x controller.
I am guessing as I have never used wafer robots before, but what is the actual error code being produced and what does it explain exactly?