Hi all, I'm accessing to DX200 in management mode and I'm trying enable the ethernet trasmission but always remain in NOT USED mode. can someone help me to enable the ethernt trasmission function? many thanks in advance.
Set the ethernet parameters to enable the transmission function
-
dset -
December 30, 2022 at 4:11 PM -
Thread is Unresolved
-
-
You need to enter the Yaskawa Mode to do that. I am not sure about DX200 but on DX100 you enter Yaskawa mode by logging into management mode, but instead of using the management mode password you use the Yaskawa mode password. Also, for DX200 Yaskawa mode might be dongle-protected, on DX100 it is just password protected.