Good day! I am trying to figure out how to start my LR Mate 200iD with an external push button wired to TBCV7/6. I can see the input light up on the I/O page but the robot will only start the cycle with the SOP start button. Thanks in advance.
Cycle start with TBCV7-6
-
jb72 -
October 5, 2022 at 8:29 PM -
Thread is Unresolved
-
-
Under the system config menu, you have to enable UOP's and set remote/local to remote.
-
I have remote/local setup set to remote, but the only line in system config that mentions UOP is UOP auto assignment, which is currently set to Simple (CRMA16)
-
It should be close to the top of the list.
-
-
Perfect, thanks!
Is there a way to start a the cycle from the pendant?