If I change the way an offset is found do i have to go through my program and touch up everything?
PR [11] is the offset being used for all my points after the length has been found.
I taught myself about searches. Sorry if this is a simple question.
Original Method:
Gets a rough measurement of
: bar length
8: J P[128] 50% FINE ;
9: Search Start [1] PR[41] ;
10: L P[145] 600mm/sec FINE Search[Y] ;
11: Search End ;
12: ;
13: Touch Offset End ;
14: Fine tuning bar length;
15: J P[160] 50% FINE Offset,PR[41:2nd bar search] ;
16: Search Start [2] PR[11] ;
17: L P[160] 600mm/sec FINE Search[-Y] ;
18: Search End ;
Newer Method
4: --:Gets a rough measurement of
: bar length ;
5:J P[1] 50% FINE PTH ;
6: SKIP CONDITION RI[1:OFF:LASER GO RANGE]=ON ;
7:L P[2] 1000mm/sec FINE Skip,LBL[99],PR[43]=LPOS ;
8: LBL[99] ;
9: ;
10: --:Adds 10mm to GP1 Pr43 Y
: value ;
11: PR[GP1:43,2]=PR[GP1:43,2]+10 ;
12: ;
13: ;
14: ;
15: Touch Offset End ;
16: ;
17: --:Fine tuning bar length ;
18:J PR[43] 50% FINE ;
19: Search Start [2] PR[11] ;
20:L PR[43] 600mm/sec FINE Search[-Y] ;
21: Search End ;
