Arc 155 Alaram comming in fanuv 120ibe after changing welding control card, Panasonic GB 2 welding machine.
Help Help Help
Arc 155 Alaram comming in fanuv 120ibe after changing welding control card, Panasonic GB 2 welding machine.
Help Help Help
Did you configure the new card?
The listed remedy to your fault code is:
Confirm port setup and connection cable.
Card Changed but no result,
How to set up port ??
All connetion cable checked found ok,
Need Help 🥺
Are you sure that the cable is OK?
Have you tried to config the I/O port and do a cold start after it?
Now Arc-143 Alarm is comming, all cable, card checked 🥺🥺
No solution 😔😔