Hi all.
I have started a project with a 460 using conveyor tracking with the dsqc2000. I have experience in the past with the dsqc377 however, this is my first project with the newer option.
I have followed to conveyor tracking manual and have it setup. However, the robot only sometimes steps past the WaitWobj line.
I have checked the wiring of the sensor and confirm the led on the CTM turns on when the sensor is triggered. Also a DI (SoftSyncTrig?) Also changes state.
I did have the StartWinWidth set to 0 (now set to 20) which would have been a problem but this didn't solve my issue. I am confident it is a setting somewhere but I am at a loss.
Any advice is appreciated