Use QuickConnect on KUKA KR C4 V8.3.x with EthernetIP V2.0.3
I searched in the Forum, but didn't found what I look for.
Problem:
To improve cycle time, I need to make sure that I can use QuickConnect EthernetIP devices on Tool changers. I have around 20 robots, that I try to improve.
Solution:
Looking trough manuals of KUKA, Turck, Balluff, SMC, I need to either enable QuickConnect under Device, Exclusive Owner, Configuration settings or I need to use Explicit messaging.
Like the Turck Device, you just activate it and you're done.
But other devices like SMC don't show this tab and according to their manual, you have to enable it using explicit messaging.
I need a solution that works:
Following all the required steps, I end up that I am not able to go online with EthernetIP. Even though I connect my Laptop to the KLI, ping all necessary addresses successful and change the settings for EthernetIP, I just get
Also turned my Firewall off and disabled all other Network adapters.
KUKA has been no help so far.
Anybody ever got Online with EthernetIP in WorkVisual?
I used WV V4. and V6.