Hello,
I'm trying to communicate between S420 Rj2 controller and Windows XP computer.
I made the communication cable as I read in this thread: Unable to reconnect Fanuc 420i rj2 to the pc (using kfloppy)
I set up the computer's COM1 port (baud, stop bits, parity) and the same parameters on TP.
I started KFloppy, set the port parameters too just as I read in this thread: Re: No communication, RJ2 Backup: device error
But I don't really know how should I proceed to be able to start the communication.
What are the steps and which order I have to make to copy from the controller, and to copy to the controller.
What is emulate option in KFloppy for?
I tried to run emulate command and in the mean time I tried to send from the controller, but TP give Device error message.
Any documentation how to use KFloppy?