Tcp bulls eye error

  • Place your Ad here!
  • Try runnning the routine BeRefPnt and see how the weldinggun stands, the wire should be on top of the tip and then try to rotate wiht the gun, wire and the tip should be together plus minus 1mm then it is perfect. I have attached pictures of how it is wiht me. First picture is what comes up when you run the routine, here you need to press day1 and then your gun should be as pictures 2 and 3, if not try to make a new setup, run the routine BeToolSetup, routine should tell you what to do, If you make a new setup you have to correct all your welds, if your lucky it is only with a few mm. Remember to take a back up before you start.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account
Sign up for a new account in our community. It's easy!
Register a new account
Sign in
Already have an account? Sign in here.
Sign in Now

Advertising from our partners