I am new to robotics and I am working with a 30iB Mate controller. I went intoa controlled start to change a variable and now I am stuck in controlled start. When I try to use FCN->COLD START, it says it will cold start after during "Auto Update." I am using a flash drive for backup/software installs. My question is how do I "Auto Update"? Do I need to load certain software on the flash drive? Every time I try to just power cycle the controller it goes right back into controlled start.https://discord.software/ FetLife vshare
Controlled Start Loop!!
-
harrymickenzy -
June 25, 2019 at 1:02 PM -
Thread is marked as Resolved.
-
-
It sounds like the system is corrupted. Have you tried loading an image in maintenance start?