Right now all robots are power down, to help mechanicks I'm connecting robots through an adapter on the wall. Last time I have power up a robot I could move it, but next time when I tried to move it after I have connected it to the power, during the loading I have symbols like this. I tried to wait like more than an hour but it didn`t help. The error occurs during the loading of the controller. I couldn`t get the controller start, I tried the F1+F5, and back and FWD buttons with no results. I would be glad for any help. I should also post that the operating system is from the 1994 year
Strange error on Fanuc r-j3ib
-
Kask -
May 10, 2019 at 8:08 PM -
Thread is marked as Resolved.
-
-
I don't think this is due to the system, the software. I have robots that I've made mistakes with on the control panels. Usually the cause of the failure is short circuit or disconnection of the control cable. Another possibility is that the electronic parts on the card inside the control can be a problem.
-
byrol you were right, it turned to be damaged teach panel cable.