Hi All,
I am trying to change stroke limits ( from 800mm to 100 mm) on J1 AXIS on R-30ib controller but I cant overwrite current settings and I am not sure where can I disable this from sys variables.
Thx
Stroke limit setup
-
vrbasgrad93 -
March 27, 2019 at 2:01 AM -
Thread is marked as Resolved.
-
-
You can change the axis limits in Menu>Next>System>Axis limits then cycle power after a change is made.
Stroke limit i've never messed with but it looks like you go into system variables $MRR_GRP[2] then $SLMT_J1_NUM and it'll tell you your current limit. Maybe you can change it there. I found this under Menu>Setup>Stroke Limit. Hope this helps.