Hello to all.
Please, help to setup IPG power source to Fanuc 30iB controller. Robot Controller is Master, IPG is Slave.
In the attachment there is a .GSD file IPG (HIL_7504.gsd), screenshot of
the IPG board settings (factory, 5W Profibus PC104 Slave
Configuration.pdf)
The main problem, as I think, is in setting up SLAVE PARAMETER (CONFIG DATA)
In the attachment there is AOA (all of above) of the robot with only one
error PROF-010 Config fault (10).
Also in the attachement there is a .doc file with comments what I wrote in the settings and where.
WBR