Problem:
When CP motion runs during an external axis moves, the robot doesn't reach expected velocity.
Situation:
I set some of parameters as below.
-$VEL.CP = 0.1
-$OV_PRO = 100%
At the points from P0 to P6 , the velocity gets 0.1[m/s] running this sample code with automatic mode.
The problem is it doesn't get 0.1[m/s] from P7 where the external axis starts to move.
---------------sample------------------
LIN {X 0,Y 0,Z 0,E1 0} C_DIS ;P0
LIN {X 1000,Y 0,Z 100,E1 0} C_DIS ;P1
LIN {X -1000,Y 0,Z 100,E1 0} C_DIS ;P2
LIN {X 1000,Y 0,Z 100,E1 0} C_DIS ;P3
LIN {X -1000,Y 0,Z 100,E1 0} C_DIS ;P4
LIN {X 1000,Y 0,Z 100,E1 0} C_DIS ;P5
LIN {X -1000,Y 0,Z 100,E1 0} C_DIS ;P6
LIN {X 1000,Y 0,Z 100,E1 180} C_DIS ;P7 the external axis starts to run from here
LIN {X -1000,Y 0,Z 100,E1 359} C_DIS ;P8
---------------sample------------------