Dear SIR
I have the 3 Fanuc robots S420IF system control R-J2.
I can use 2 robots another one can't use because of software program.
I want to know. How to install the software and program?
Can I copy the software program from 2 robots?
Thanks you in advance
Panya M.
panya.m@ana-auto.com
HOW TO INSTALL PROGRAM FOR FANUC ROBOT
-
panya_m -
September 8, 2018 at 12:11 AM -
Thread is marked as Resolved.
-
-
Dear SIR
I have the 3 Fanuc robots S420IF system control R-J2.
I can use 2 robots another one can't use because of software program.
I want to know. How to install the software and program?
Can I copy the software program from 2 robots?
Thanks you in advance
Panya M.
panya.m@ana-auto.com -
panya_m
Your robots are a little bit old, so you might not get an answer because most of the people have newer robots.
I call "software" what the Fanuc operating system is and I call "program" the logic that I write
Are you having problems with the software revision ? Can you post what do you have for each robot.
-
Thanks you Sir
I will find the program revision for fanuc robot that I have.
After that I will tell you again.
Panya M.